Filling and Bagging Weigh Controller PCB Kit

The Kit contains the following items.

• Filling & Bagging Weighing Controller PCB R5.0V1 – 1no.
• 0.56” Red display – 1nos.
• 4-input Keypad with connector – 1nos.
• Optically Isolated Relay PCB – 1no.
• 0-12V/1Amps transformer – 2no.
• 0-15V/1Amps transformer – 1no.

The filling & bagging weigh controller system provides 3-relay output for controlling the bag filling & weighing process.

• Relay1 – Connected to bag holding clamp actuator.
• Relay2 – Connected to coarse filling actuator. This relay operates from zero weight to set-point1 value.
• Relay3 – Connected to fine filling actuator. This relay operates from zero weight to setpoint2 value. The input control buttons used in the controller are…
• SHIFT key (K3) – Instructs the controller to start the filling process.
• TARE key (K4) + Shift key (K3) – To program the set-point1 & set-point2 values in the controller.